Removing Switch For Power Windows (Front Door)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Information
- The front locking lug can be accessed through the bore.
- Only make the bore hole as deep as required so as not to damage the locking lug.
Information
Lightly press switch for power windows (front door) -1- up through the opening -2- during the entire loosening process -Arrow- .
Switch for power windows (front door)
Installation position of switch for power windows (front door)
- Release and disconnect electric plug connection for ambient lighting -1-
.
Ambient lighting in storage compartment
- Remove electric plug connection for switch for power windows (front door) -2-
.
Switch for power windows (front door)
- Make bore hole -1-
in door panel.
Bore in door panel
1 > Diameter 5 mm A > Length 9 mm B > Length 3.1 mm - Detach switch for power windows (front door).
- 4.1 Disengage locking lug -1-
through the bore hole -2-
using a screwdriver.
Locking lug
- 4.2 Disengage locking lug -1-
through the opening on the component -2-
using > 9893 - disassembly tool
.
Locking lug
- 4.3 Turn the door panel around.
- 4.4 Unclip cap -1-
using an assembly wedge. -arrow-
Cap
- 4.5 Disengage locking lug -1-
through the opening on the component -2-
using > 9893 - disassembly tool
.
Locking lug
- 4.6 Disengage locking lug -1- through the opening on the component -2- using > 9893 - disassembly tool .
Locking lug
- 4.1 Disengage locking lug -1-
through the bore hole -2-
using a screwdriver.
- Remove switch for power windows (front door).
- Unclip switch for power windows (front door) using > 9893 - disassembly tool . ADD ANIMATION CROSS-REFERENCE HERE.