Installing Rear Logo
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Carefully clean any dirt, grease, wax and other impurities off the fitting area of the body using isopropyl.
- Always use a clean cloth.
- The room and object temperature must be at least > Nominal value + 15°C .
- Air humidity must be > Nominal value 50 % +/- 10 % .
- Do not touch the bonding surface again after removing the protective paper.
- Wear clean gloves during the bonding process in order to guarantee adequate adhesion.
- The parts must have been bonded for at least > Nominal value 72 h before washing the vehicle in a car wash.
Information
To ensure that the logo template does not lose its shape, always store the logo template on the relevant support (packaging) after using it.