LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (66 Exterior Equipment - Wagon -- 971 - PANAMERA (971)) >> WM, 664719 Removing And Installing Moulding For Rear Lid >> Installing Moulding For Rear Lid

Installing Moulding For Rear Lid

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Installation is performed in reverse order. Pay particular attention to the following:

    Tightening torque for screw on tailgate cover: > Tightening torque 4 Nm (3 ftlb.) 

    Tightening torque for screws on middle cover: > Tightening torque 4 Nm (3 ftlb.) 

scientia non olet · About LEMON Manuals