Working On Surfaces
WARNING: This page is about a different car, the 2023 Porsche Panamera and 2022 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Excessively high dust concentration during grinding work
- Risk of explosion
→ Remove any grinding dust using the relevant vacuum cleaner approved for use on the material.
→ Remove dust in the work area regularly.
→ Do not use compressed air to blow away dust deposits.
→ Always separate the dust from different materials (separate aluminium, steel and carbon fibre-reinforced plastic).
→ Clean the extraction system at regular intervals.
→ Never weld and grind in the same room at the same time.
→ Only use pneumatic grinders if possible.
- Only use stainless-steel wire brushes.
- Use special grinding and cutting discs for aluminium.
- Use P 80 to P 200-grain grinding discs.
- Observe corrosion protection measures.