Pulling Punch Rivets
WARNING: This page is about a different car, the 2023 Porsche Panamera and 2022 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Information
The following description is intended only as a guide. A description of the steps involved and the various areas of application can be found in the operating instructions provided with the respective device.
- Set up stud welder and prepare components for welding.
Welding parameters for pulling punch rivets
Bolt Welding time [ms] Amperage rating [A] Lift [mm] Gas preflow time [ms] Gas parameters [l/min] Power terminal Ground terminal Polarity Stainless-steel bolt, M6 32 650 1.0 1000 10 Component Gun Polarity reversed Stainless-steel bolt, M5 30 600 1.0 1000 Component Gun Polarity reversed - Weld the stainless steel stud onto the rivet head of the punch rivet.
Welding on weld stud
Information
If there is also adhesive in the joint area of the punch rivet, heat it using a > V.A.G 1416 - hotair blower to make it easier to pull it out and prevent the stainless steel pin from breaking.
- Pull out punch rivet at the welded-on weld stud using a hydraulic riveting tool > VAS 6790 - Compact booster with tool attachment > VAS 6792/2 - Extension .
Pulling punch rivet