LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (39 Final Drive Differential, Differential Lock 4.0L Turbo Hybrid -- 971 - PANAMERA (971)) >> WM, 398819 Removing And Installing All-Wheel Final Drive (V8) >> Removing All-Wheel Final Drive

Removing All-Wheel Final Drive

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Danger of objects or loads falling down 
  • Risk of squashing or crushing 

    → Secure components to prevent them from falling down.

  1. Fit impact puller.
    1. 1.1 > 9799 - Impact puller  must be fitted at the groove in the connecting shaft using four screws -1-  .
    G15889173Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Fitting tool (similar to illustration)

  2. Loosen connecting shaft.
    1. 2.1 Use > 9799 - impact puller  to remove connecting shaft from all-wheel final drive -arrow-  .
    G15889174Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Removing and fitting connecting shaft (similar to illustration)

  3. Remove console.
    1. 3.1 Unscrew fastening screws -1-  and remove console -2-  .
    2. 3.2 Remove circlip -3-  .
    G15889175Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Final drive console

  4. Suspend engine using workshop crane and > 3033 - lifting tackle  .
  5. Left side of engine:
    1. 5.1 Loosen engine mount -4-  from engine carrier -5-  .
      1. 5.1.1 Loosen and unscrew screw -3-  .
    2. 5.2 Press drive shaft -1-  off the all-wheel final drive console -2-  (-arrow-  ) and guide it out carefully.

      > 404119 REMOVING AND REINSTALLING FRONT DRIVE SHAFT

    G15889176Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Drive shaft and left engine mount (V8 biturbo engine)

  6. Right side of engine:
    1. 6.1 Loosen engine mount -4-  from engine carrier -5-  .
      1. 6.1.1 Loosen and unscrew screw -3-  .
    2. 6.2 Lift the engine up slightly.
    3. 6.3 Press drive shaft -1-  off the all-wheel final drive -2-  and guide it out carefully.

      > 404119 REMOVING AND REINSTALLING FRONT DRIVE SHAFT

    G15889177Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Drive shaft and right engine mount (V8 biturbo engine shown)

  7. Remove right engine carrier.
    1. 7.1 Unscrew fastening screws -1-  and remove engine carrier -2-  .
    G15889178Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Right engine carrier

  8. Disconnect coolant lines -3-  .
    1. 8.1 Unscrew nut -1-  and screw -2-  and swivel coolant lines -3-  aside.
    G15889179Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Disconnecting coolant lines

  9. Remove all-wheel final drive.
    1. 9.1 Unscrew screws -4-  and remove all-wheel final drive -3-  .
    G15889180Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Front-axle final drive