LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (72 Seat Frames - Wagon -- 971 - PANAMERA (971)) >> WM, 726719 Removing And Installing Rear Backrest Mount >> Removing Rear Backrest Mount >> Removing Load-Through Provision Mount

Removing Load-Through Provision Mount

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull off spacer sleeve -1-  .
    G15874576Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Spacer sleeve

  2. Pull out bearing pin -2-  .
    G15874577Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Bearing pin

  3. Unclip bearing sleeve -3-  from load-through provision.
    G15874578Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Bearing sleeve

  1. Detach cover for rear backrest -1-  in the lower area.
    G15874579Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Cover for rear backrest

  2. Carefully press the padding down until the relevant nut -1-  is accessible.
    G15874580Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Padding

    Information 

    To unscrew the bearing pin, counter at the inner nut using a wrench.

  3. Unscrew the relevant bearing pin -2-  and remove it.
    G15874581Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Bearing pin

scientia non olet · About LEMON Manuals