General Information
Information
The guide plate VAS 5161A/38 must be modified for cylinders 4 and cylinder 8.
Screw two M8 bolts into the VAS 5161A/38 guide plate as shown in the illustration.
The screws must project by max. 5 mm at the bottom.
The projection of the screws is fitted at the oil ducts.
The next steps are described in the Workservice information.
The screws in the guide plate VAS 5161A/38 can remain fitted for working on the other cylinders.
Accessory for VAS5161A/38
| 1 | Guide plate VAS 5161A/38 |
| 2 | Screws, M8 x 35 (Part No.: N 108 063 01) |
| 3 | Oil ducts |
Information
On cylinders 4 and 8, the guide plate VAS 5161A/38 can -1- only be secured -2- to the cylinder head with a screw.
VAS 5161A/38
Information
In the > VAS 5161A/38 - guide plate-1- there are four bores -a, b, c, d- for mounting on the cylinder head.
Depending on the installation situation, observe the use of the bores and secure the > VAS 5161A/38 - guide plate-1- with the supplied M6 x 40 bolts -2- .
Guide plate VAS 5161A/38 with screws
| E | Intake side |
| A | Outlet side |
Information
For the exhaust side valve, attach the > VAS 5161A - valve keeper tool as shown.
Valve springs outlet side
| 1 | Pressure fork VAS 5161/2 |
| 2 | Retainer VAS 5161/6 with threaded studs VAS 5161/5 |
| 3 | Assembly cartridge VAS 5161/8A |
- If the valve keys were removed from the assembly cartridge, they must first be inserted into the insertion device VAS 5161/18 -1-
from the tool kit > VAS 5161A - Removal and installation device for valve keys
.
- 1.1 Insert valve keys into the insertion device VAS 5161/18.
- 1.1.1 The large diameter of the valve keys must be facing upwards.
- 1.2 Press assembly cartridge VAS 5161/8 onto the valve keys from above and pick up the valve keys.
- 1.1 Insert valve keys into the insertion device VAS 5161/18.
Insertion device VAS 5161/18