Subsequent Work: Notes
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
- Secure pressure hoses at the bottom on both sides of the charge-air cooler.
> 2X00IN Technical values (V6 biturbo)
- Install air guide -1-
at the radiator frame.
Air guide at top of radiator frame
- Install air-cleaner cowl.
- Secure both suction hoses -1-
. Fit suction hoses and fasten clamps -3-
.
Suction hose
- Install engine cover.
> 108319 Removing and installing engine cover (design cover) (V6 biturbo)
- Install engine compartment trim panel.
> 700219 REMOVING AND REINSTALLING FRONT TRIM PANEL (ENGINE COMPARTMENT)
- Install front wheel housing liners.
> 505619 Removing and installing front wheel housing liner
- Install rear cardan shaft.
- Secure ATF lines to the ATF cooler.
> 386219 Removing and installing line for ATF cooling
- Secure air-conditioning lines to the cooler.
- Install exhaust system.
- Connect battery ground strap.
- Start the high-voltage system.
> 2X00IN Isolating high-voltage system from power supply/Starting high-voltage system
- Fill up coolant.
> 193817 DRAINING AND FILLING COOLANT (INCLUDES BLEEDING)
> 193817 Draining and filling coolant (low-temperature cooling system)
- Connect battery ground strap.
- Fill in refrigerant.
- Check engine oil.
- Fill in ATF.
- Perform suspension alignment.
- Perform a test drive.
After the cooling system has cooled down again, check the engine coolant level in the reservoir and top up to the Maximum mark if necessary.