Installing Coolant Temperature Sensor
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Information
- O-rings must always be replaced.
- O-rings must be coated lightly with Kluber Syntheso Glep.
- Installation is performed in reverse order.
- Replace O-rings and grease with Kluber Syntheso Glep.
- Screw in and tighten screw on coolant temperature sensor.
> Tightening torque 9 Nm (6.5 ftlb.)
- Tighten screw on screw-type clamp securing pressure hose for charge-air cooler to pressure pipe > Tightening torque 5.5 Nm (4 ftlb.) +/- 0.5 Nm (0.3 ftlb.)