Removing Change-Over Valve For Low-Temperature System

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Hot fluid

Danger of scalding
→ Avoid contact with hot fluid.

→ Wear personal protective gear.

Loosen holder -1- .
1. 1.1 Screw off nut -2- .
2. 1.2 Unscrew and remove screws -3- .
3. 1.3 Move holder -1- so that the low-temperature circuit temperature sensor is accessible. Make sure not to damage any lines.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bracket
Remove change-over valve for low-temperature system -1- .
1. 2.1 Loosen spring band clamps -2- using > VAS 6890 - Spring Band Clamp Pliers and pull off coolant hoses -3- .
2. 2.2 Catch escaping coolant and close off line connections using suitable stoppers.
3. 2.3 Release and disconnect cable plug -4- .
4. 2.4 Unscrew nuts -5- .
5. 2.5 Remove change-over valve for low-temperature system -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Change-over valve for low-temperature system (UVW 1)