Installing Change-Over Valve For Low-Temperature System

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Install change-over valve for low-temperature system -1- .
1. 1.1 Fit change-over valve for low-temperature system -1- .
2. 1.2 Screw on and tighten nuts -5- .
  > Tightening torque 8 Nm (6 ftlb.)
3. 1.3 Connect and lock cable plug -4- .
4. 1.4 Push on coolant hoses -3- and tighten spring band clamps -2- using > VAS 6890 - Spring Band Clamp Pliers .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Change-over valve for low-temperature system (UVW 1)
Secure holder -1- .
1. 2.1 Move holder -1- into installation position.
2. 2.2 Fit nut -2- and screws -3- .
3. 2.3 Tighten screws -3- .
  > Tightening torque 8 Nm (6 ftlb.)
4. 2.4 Tighten nut -2- .
  > Tightening torque 6 Nm (4.5 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bracket