Installing Coolant Regulator (Thermostat Insert)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Information
Install seals with open side facing the engine.
- Installation is performed in reverse order.
- Install seals -1 and 2-
.
Installing seals
- 2.1 Push in seal -1- using > T40357 - pressure piece -2- and tap it in as far as it will go.
- 2.2 Install seal -3- .
- Screw in and tighten screws for coolant regulator (thermostat insert) > Tightening torque 9 Nm (6.5 ftlb.)
- Screw in and tighten screws on screw-type clamps on the suction hose.
> Tightening torque 3.5 Nm (2.5 ftlb.)
> Tightening torque 3.5 Nm (2.5 ftlb.)