LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (63 Bumper - Coupe -- 971 - PANAMERA (971)) >> WM, 635719 Removing And Installing Rear Retaining Strip >> Installing Retaining Strip With Heat Shield

Installing Retaining Strip With Heat Shield

WARNING: This page is about a different car, the 2023 Porsche Panamera and 2022 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Installation is performed in reverse order.
  2. Screw in and tighten nuts on retaining strip with heat shield > Tightening torque 9 Nm (6.6 ftlb.) 
  3. Screw in and tighten screw on retaining strip with heat shield > Tightening torque 2.5 Nm (1.8 ftlb.) 
scientia non olet · About LEMON Manuals