LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (63 Bumper - Coupe -- 971 - PANAMERA (971)) >> WM, 635719 Removing And Installing Rear Retaining Strip >> Installing Centre Retaining Strip And Retaining Strip For Tail Light

Installing Centre Retaining Strip And Retaining Strip For Tail Light

WARNING: This page is about a different car, the 2023 Porsche Panamera and 2022 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Installation is performed in reverse order.
  2. Screw in and tighten nuts on retaining strip for tail light > Tightening torque 3.5 Nm (2.6 ftlb.) 
  3. Screw in and tighten nut on centre retaining strip at the bottom > Tightening torque 3.5 Nm (2.6 ftlb.) 
  4. Screw in and tighten nuts on centre retaining strip > Tightening torque 6 Nm (4.4 ftlb.) 
scientia non olet · About LEMON Manuals