Installing Supply Line (Section From Fuel Tank To Engine)
- Installation is performed in reverse order. Pay particular attention to the following:
Make sure that locks on connections engage securely.
Replace fastening screws on the reinforcement strut!
Fastening screws for cover > Tightening torque 8 Nm (6 ftlb.) .
Fastening screw -7- for reinforcement strut -3- > Initial tightening 70 Nm (51.6 ftlb.) > Final tightening + 180° .
Fastening screw -8- for reinforcement strut -3- > Initial tightening 50 Nm (36.9 ftlb.) > Final tightening + 45° .
Front-axle carrier