Installing Strut

1. Installation is performed in reverse order. Observe specified tightening torques:

1. 1.1 Secure the strut -1-  .

   A-strut to cowl panel -2-  : > Tightening torque 40 Nm (30 ftlb.) 

   A-strut to cross panel -3-  : > Tightening torque 8 Nm (6 ftlb.) 

   Spring strut with A-strut to body -4-  : > Initial tightening 40 Nm (30 ftlb.)  > Final tightening + 45° 

   A-strut to body -5-  : > Initial tightening 20 Nm (15 ftlb.)  > Final tightening 90° 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Strut mounting

2. 1.2 Upper part of plenum panel at the side to spring strut mount: > Tightening torque 8 Nm (6 ftlb.) +/- 15 % 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Side plenum panel to spring strut mount

3. 1.3 Screw securing upper part of plenum panel at the centre to A-strut -1-  : > Tightening torque 8 Nm (6 ftlb.) +/- 15 % 

Upper part of plenum panel at the side to centre plenum panel -2-  : > Tightening torque 4 Nm (3 ftlb.) +/- 15 % 

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screws for A-strut