Installing Front-Axle Support (Front Sections)

1. Tighten screws -2 and 3-  .

   -2-  : > Tightening torque 55 Nm (41 ftlb.) 

   -3-  : > Tightening torque 30 Nm (22 ftlb.) 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Mounting for front-axle support (front section)

2. Fit add-on parts on front-axle support.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for add-on parts

1. 2.1 Tighten screws -1-  for oil lines > Tightening torque 6 Nm (4.5 ftlb.) 
2. 2.2 Tighten screws -2-  for oil line/oil cooler holders > Tightening torque 8 Nm (6 ftlb.) 
3. 2.3 If installed:  Fit expansion rivets -3-  for heat insulation. (Only at the right on petrol engines).