| Upper control arm to wheel bearing housing |
M12 thread |
Tightening torque |
95 Nm (70 ftlb.) |
|
|
| Tie rod to rear axle housing |
M12 thread/always use new screws or bolts and nuts following removal |
Tightening torque |
95 Nm (70 ftlb.) |
|
|
| Tie-rod ball to tie rod |
Counter when loosening and tightening the lock nut on the outer joint |
Tightening torque |
90 Nm (67 ftlb.) |
|
|
| Fastening screws |
Heat shield to front-axle carrier |
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Fastening screw |
Heat shield to front-axle carrier |
Tightening torque |
20 Nm (15 ftlb.) |
|
|
| Fastening screw |
Step 1, front-axle carrier to body |
Initial tightening |
115 Nm (85 ftlb.) |
|
|
| Fastening screw |
Step 2, front-axle carrier to body |
Final tightening |
+90° |
|
|
| Fastening screw |
Step 1, front-axle carrier to body |
Initial tightening |
115 Nm (85 ftlb.) |
|
|
| Fastening screw |
Step 2, front-axle carrier to body |
Final tightening |
+90° |
|
|
| Fastening screw |
Fastening screw on transmission support |
Tightening torque |
70 Nm (52 ftlb.) |
|
|