Technical values
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATION
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Connecting link to anti-roll bar | M10 x 65 thread/always use new screws and nuts following removal | Initial tightening | 50 Nm (37 ft. lb.) | ||
| Connecting link to anti-roll bar | M10 x 65 thread/always use new screws and nuts following removal | Final tightening | +90° | ||
| Connecting link to lower trailing arm | M10 x 65 thread/always use new screws or bolts following removal | Initial tightening | 50 Nm (37 ft. lb.) | ||
| Anti-roll bar clamp to rear axle carrier | M8 x 65 thread/always use new screws following removal | Initial tightening | 20 Nm (15 ft. lb.) | ||
| Anti-roll bar clamp to rear axle carrier | M8 x 65 thread/always use new screws following removal | Final tightening | +180° | ||
| Heat shield for drive shaft to rear axle | M8 x 22 thread | Tightening torque | 20 Nm (15 ft. lb.) | ||
| Level sensor to lower trailing arm | M6 x 16 thread | Tightening torque | 9 Nm (6.5 ft. lb.) | ||
| Connecting link to lower trailing arm | M10 x 65 thread/always use new screws or bolts following removal | Final tightening | +90° |