Subsequent work

WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

Grease the part of the speed sensor located in the wheel bearing housing. .
The bore for mounting the speed sensor must be free of dirt .
Observe specified tightening torques .

Insert speed sensor -2- and tighten fastening screw -1 - . Tightening torque 8 Nm (6 ft. lb.)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Position cover plate for brake disc -2- and tighten fastening screws -1-. Tightening torque 10 Nm (7.5 ft. lb.)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Install wheel bearing housing. → 425219 REMOVING AND INSTALLING REAR WHEEL BEARING HOUSING