Installing intermediate steering shaft

WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Position intermediate steering shaft -1- from within the passenger compartment.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit intermediate steering shaft -3- as far as it will go onto the steering column -1- .
Information

Always replace the clamping screw on the universal joint.

Tighten fastening screw -2- . Tightening torque 30 Nm (22 ft. lb.)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Insert sealing bellows -1- as far as possible from within the passenger compartment.
Make sure that the two arrows -1- are pointing upwards.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Secure the sealing bellows on the underside of the vehicle.

4.1. Pull sealing bellows -1- in through the opening.
4.2. Fit the sealing bellows -1- onto the collar -2- of the body completely using the tabs without turning the sealing bellows.

4.3. Then check the installation position of the sealing bellows in the passenger compartment using the arrows. The arrows must be pointing straight up.

Loosen the sealing bellows, turn it to the correct installation position and fit it again if necessary.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fit intermediate steering shaft -1- as far as it will go onto the steering gear -3- .
Information

Always replace the clamping screw on the universal joint.

Tighten fastening screw -2- . Tightening torque 30 Nm (22 ft. lb.)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.