Installing charge-air cooler
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Replace O-rings .
- Grease O-rings with a light coating of Kluber Syntheso Glep .
- Installation is performed in reverse order.
- 1.1. Tightening torque for charge-air cooler: Tightening torque 7 Nm (5 ft lb.)
- 1.2. Tightening torque for screw-type clamp: Tightening torque 5.5 Nm (4 ft lb.)