Installing pressure pipe
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Information
The procedure for removing and installing is described for one side as an example. The procedure for the other side is practically identical.
Information
- Replace O-rings .
- Grease O-rings with a light coating of Kluber Syntheso Glep (Part No.: 000.043.204.68) .
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1. Check O-rings and replace if necessary.