Preliminary work

WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

If vehicles have fault entries relating to oil pressure, oil pump activation, oil pressure monitoring, etc. in the DME control unit (and a warning light comes "on" on the instrument cluster), proceed as follows:

Check the oil level .
Delete related faults .
Do not replace components, such as the oil pump, oil pressure sensor or oil pressure control valve if you suspect that they are faulty .

If the vehicle has not been driven for a long time (months), the control mechanism in the oil pump can become stiff ("stick").

Very short trips and a lot of loading/maneuvering can cause the oil to become very diluted => Oil pressure very low. For example, 20 cold starts in quick succession can reduce the viscosity of the engine oil by 30%.

Change the engine oil. Test-drive the vehicle .
If error messages/warnings are displayed again, proceed in accordance with the instructions under Guided Fault Finding in the PIWIS Tester .

Remove cover for front underbody.
→ 519219 REMOVING AND INSTALLING COVER FOR FRONT UNDERBODY
Remove lower pedestrian protection. → 697019 REMOVING AND INSTALLING PEDESTRIAN PROTECTION