Installing hall sender

WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

Tightening torques, tightening sequence and assembly overviews for the engine and transmission:

Group 1: → 1X00IN TECHNICAL VALUES
Group 2: → 2X00IN TECHNICAL VALUES
Group 3: → 3X00IN TECHNICAL VALUES

Information

The procedure for removing and installing is described for one side as an example. The procedure for the other side is practically identical.

Carefully install camshaft hall sender.
1. 1.1. Clean the sealing face.
2. 1.2. Check O-ring and replace it if necessary.
3. 1.3. Use new aluminum screw.
4. 1.4. Tightening torque for aluminum screw: Initial tightening 4 Nm (3 ft lb.) Final tightening +60°
5. 1.5. Plug in electric connector and lock it.
  The connector must lock with an audible click.