Removing rear section of lid-lock cable
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Unclip operating cable -2- from the bracket -3- and disconnect it.
- Remove front trim panel. → 700219 REMOVING AND INSTALLING FRONT TRIM PANEL
- Unclip operating cable -2-
from the fixing clips -1-
.
- Remove front inner door sill trim. → 680519 REMOVING AND INSTALLING FRONT INNER DOOR SILL TRIM
- Unclip operating cable -1- from release unit -2- and disengage it.
- Loosen insulating mat -3- and secure it outside the work area.
- Guide rubber sleeve -4- out of the body.
- Lubricate operating cable -1- and pull it out towards the passenger compartment.