Subsequent work
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Switch off ignition and pull remote control out of ignition lock.
- PIWIS Tester II 9818 must now be disconnected from the vehicle.
- Disconnect battery charger.
- Remove sensors and instrument holders.
Information
Before and after fitting the trim cover for the distance measuring sensor control unit, check the following points:
- The holder for the distance measuring sensor control unit must not show any signs of deformation, which may have been caused, for example, by removing or installing the trim cover for the distance measuring sensor control unit. If the holder for the distance measuring sensor control unit is deformed, carefully push it back into shape .
- If the trim cover is damaged or cracked, replace the trim cover .
- After fitting the trim cover, check that it is seated correctly and securely .
- Install trim cover -1- on the distance measuring sensor control unit.
- Perform a test drive and check operation of distance measuring sensor control unit.
- Read out the fault memory of the distance measuring sensor control unit.