Removing DC/DC converter

WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Voltage peaks

Risk of damage to load or to the control unit

→ Remove the ignition key and switch off load before disconnecting or removing load.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Switch off ignition and pull remote control out of ignition lock.

Take DC/DC converter -1- out of the holder -2- .

2.1. Disengage retaining lugs -a- .
2.2. Lift DC/DC converter up slightly at the left.

2.3. Pull DC/DC converter at the right out of the holder -b- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

Always comply with the regulations for handling ESD-sensitive components!

Always wear approved work clothes and shoes when carrying out assembly work .
Do not remove new parts from ESD (electrostatic discharge) protective packaging until shortly before installation .
Do not touch electric pins and plug contacts .

Pull slide -2- out of the electric plug connection -1- (-a- ) and disconnect electric plug connection from the DC/DC converter -A- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.