Replacing combination sensor: Notes

WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Combination sensor not calibrated or calibrated incorrectly

Unexpected vehicle handling
Combination sensor does not function
Malfunction in combination sensor

→ After installing or replacing the combination sensor, calibrate vehicle using PIWIS Tester 3 9900 .

→ Only perform calibration when the vehicle is positioned horizontally and the brake is not actuated.

Information

The combination sensor is located under the driver seat.

The functions listed below are integrated in the combination sensor:

Rotation-rate sensor
Lateral-acceleration sensor
Axial-acceleration sensor .

Cut the bar on the carpet using a sharp knife or scissors → Cutting bar .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove footwell outlet vent.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw off fastening nuts -1- on the combination sensor -2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove combination sensor and disconnect connector -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.