Subsequent work
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Bleed the brake system → 470107 BLEEDING THE BRAKE SYSTEM .
- Install front left trim panel → 700219 REMOVING AND INSTALLING FRONT TRIM PANEL .
- Bleed the brake lines again (following conventional bleeding)
using PIWIS Tester II 9818
(secondary brake circuit bleeding).
To do this, select:
> Control unit overview
> PSM
> Maintenance/repairs
> Bleed brakes
To finish, follow the menu guidance in PIWIS Tester II 9818 .
- If the hydraulic unit was replaced, code the control unit for the hydraulic unit → 453055 REPLACING HYDRAULIC UNIT .
- Carry out a swap test using PIWIS Tester II 9818
.
To do this, select:
> Control unit overview
> PSM
> Maintenance/repairs
> Hydraulic swap test
To finish, follow the menu guidance in PIWIS Tester II 9818 .
- Perform a function test.
- 6.1. During the test drive, perform at least one ABS control operation, taking the road conditions into consideration.
- 6.2. On vehicles with PDK transmission, test the HOLD function if possible. If the combination sensor has been taught incorrectly, the Hold function will not be active for inclines of more than 5%!
- 6.3. Read out the fault memory. There must not be any stored faults.