Replacing rear level sensor: Notes
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Information
Either two or four level sensors are installed on the vehicle, depending on equipment variant:
- Steel springs without PASM: only left side of the vehicle (front and rear axle)
- Air springs and steel springs with PASM: left and right side of the vehicle (front and rear axle)
- Release and disconnect electric connector -1- .
- Unscrew fastening screw -2- on the lower trailing arm.
- Unscrew fastening screw -3- on the rear axle housing.
- Remove level sensor.