Conditions for carrying out calibration
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Calibration can only be carried out while the vehicle is stationary .
- The vehicle must stand "floating" on the measuring platform to avoid straining the axles .
- Calibration is also required for the variants with "steel springs - PASM". The headlight beam adjustment (HBA) sensors are also calibrated .
- Before calibration is performed, the vehicle must be adjusted to Normal level and the Height sensor system component test must be carried out!
- Check that the tyre pressure is set in accordance with the respective tyre specifications! (>>4405IN Wheels and tyres)
- The vehicle is raised and lowered during the height sensor system component test and then adjusts to the correct level!
- The measured values for the vehicle height must correspond approximately to the values specified under Adjustment values for suspension alignment . An implausible value will not be accepted. For the current comparative values for the vehicle height, please refer to the adjustment values for suspension alignment → 4495TW ADJUSTMENT VALUES FOR SUSPENSION ALIGNMENT
- Do not cancel calibration! If calibration is interrupted, the fault code 000286 "Customer service mode not complete" remains stored and is active! A warning appears in the instrument cluster. Select >>Drive links/checks<< in the menu. Delete the fault memory and perform calibration again!