Removing intake-air distributor

WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect connector -a- on the throttle housing and pull cable out of the clip.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Disconnect connector -a- on change-over valve for acoustic simulator -1- .

2.1. Pull the line out of the clip -2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Disconnect connector -a- from the throttle valve heat sockets -1 and 2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Disconnect connector -a- on the pressure converter -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Disconnect connector -a- on boost pressure sensor -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Disconnect connector -a- on change-over valve -1- .

6.1. Pull change-over valve -1- off the holder.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Disconnect connectors -a- on the high-pressure pumps -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Disconnect connector -a- on the tank vent valve -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Disconnect connector -a- on the vacuum sensor for diagnosis -2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Disconnect connector -a- on the fuel pressure sensor (low-pressure) -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Loosen screws -1 to 8- .
1. 11.1. Remove intake-air distributor.
  
  Fig 1: Intake-Air Distributor Screws Tightening Sequence
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.