Technical values
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATION
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Upper control arm to wheel bearing housing | M12 thread | Tightening torque | 95 Nm (70 ft. lb.) | ||
| Tie rod to rear axle housing | M12 thread/always use new screws or bolts and nuts following removal | Tightening torque | 95 Nm (70 ft. lb.) | ||
| Tie-rod ball to tie rod | Counter when loosening and tightening the lock nut on the outer joint | Tightening torque | 90 Nm (67 ft. lb.) | ||
| Fastening screws | Heat shield to front-axle carrier | Tightening torque | 9 Nm (6.5 ft. lb.) | ||
| Fastening screw | Heat shield to front-axle carrier | Tightening torque | 20 Nm (15 ft. lb.) | ||
| Fastening screw | Step 1, front-axle carrier to body | Initial tightening | 115 Nm (85 ft. lb.) | ||
| Fastening screw | Step 2, front-axle carrier to body | Final tightening | +90° | ||
| Fastening screw | Step 1, front-axle carrier to body | Initial tightening | 115 Nm (85 ft. lb.) | ||
| Fastening screw | Step 2, front-axle carrier to body | Final tightening | +90° | ||
| Fastening screw | Fastening screw on transmission support | Tightening torque | 70 Nm (52 ft. lb.) |