Teaching additional handset/telephone handset
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Information
The PIWIS Tester 3 9900 instructions take precedence since the description may be different with later Tester releases.
The procedure described here has been structured in general terms. Different text or additional information may appear in PIWIS Tester 3 9900 .
CAUTION:
Voltage drop
- Risk of damage to control unit
- Fault entries in the control unit
- Coding in the control unit is aborted
- Malfunctions in control unit, even during programming
→ Ensure that the power supply is not interrupted during programming.
→ Connect a battery charger with a current rating of at least → Nominal value: 40 A to the vehicle battery.
- Connect the Tester to the vehicle and start it. Switch on ignition.
- Select the vehicle type if required.
- Select the PCM control unit in the overview . Press [F12] to continue. The message "Create Vehicle Analysis Log (VAL)?" appears. Press [F11] to continue.
- Drive links/checks must now be selected. Press [F12] to continue.
- PCM drive links must be selected. Press [F12] to continue.
- Engage additional handset in the charging cradle.
- Teach handset must be selected. Press [F12] to continue.
- Start the activation process by pressing [F8].
- Read the information displayed on the Tester. The entry Activation (value = on) is required. Press [F11] to go back.
- Exit the diagnostic application.
- Switch off the ignition.
- Disconnect the Tester from the vehicle.
- Check the function of the handset.