Removing antenna control unit
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Information
Always comply with the regulations for handling ESD-sensitive components!
- Always wear approved work clothes and shoes when carrying out assembly work .
- Do not remove new parts from ESD (electrostatic discharge) protective packaging until shortly before installation .
- Do not touch electric pins and plug contacts .
- Switch off ignition and pull remote control out of ignition lock.
- Pull antenna connector -1-
off the antenna control unit -2-
.
Information
The number of plug connections can vary, depending on equipment.
- Pull locking mechanisms on the antenna connectors -3- out slightly, press them -a- and pull antenna lines off the antenna control unit.
- Release antenna connectors -4- (-b- ) and pull them off the antenna control unit.
- Unscrew fastening screw -5- .
- Swivel antenna control unit out and pull it to the left and out of the tailgate.