Adjusting lock peg
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Information
- The striker pin can be adjusted by changing the plasticity of the adjusting element in the B-pillar .
- The setting is retained when the striker pin is removed .
- Loosen fastening screws -2- .
- Move lock peg outwards.
- 2.1. Move the lock peg -1- outwards (if necessary) using slide hammer kit Nr.168 .
- Adjust the lock peg back/down/up (if necessary).
- 3.1. Move catch bar -1- to the required position using a plastic hammer.
- 3.2. Carefully close the door and check adjustment.
- Tighten fastening screws -2- to Tightening torque 25 Nm (19 ft lb.) until secure.