Adjusting lock peg

WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

The striker pin can be adjusted by changing the plasticity of the adjusting element in the B-pillar .
- The setting is retained when the striker pin is removed .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Loosen fastening screws -2- .
Move lock peg outwards.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 2.1. Move the lock peg -1- outwards (if necessary) using slide hammer kit Nr.168 .
Adjust the lock peg back/down/up (if necessary).

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 3.1. Move catch bar -1- to the required position using a plastic hammer.
2. 3.2. Carefully close the door and check adjustment.
Tighten fastening screws -2- to Tightening torque 25 Nm (19 ft lb.) until secure.