Removing rear B-pillar cover

WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

The number of fastening screws, fixing clips, plug connections, holders and trim panels can vary depending on equipment.
The illustrations for removing and installing the drive mechanism are shown only on one equipment variant and may differ from the actual equipment variant.
Some steps must be carried out automatically.
Some of the repair illustrations show only one side of the vehicle.

Remove window frame cover -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove cover -1- for door inner panel.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Slide door window glass down until the mounting -4- is accessible through the door inner panel.
Loosen door window glass -1- from the mounting point -4- on the power windows mechanism.
1. 4.1. Actuate locking mechanism -2- and remove limit stop -3- on the power windows mechanism.
  Move door window glass -1- down until the locking mechanism -5- is accessible.
  
  Actuate locking mechanism -5- using a suitable tool -arrow A- and carefully raise the door window glass -1- (-arrow B- ).
2. 4.2. Pull door window glass -1- fully up -arrow B- out of the mounting point -4- .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Pull inner rubber seal -1- in the side area of the cover and at the bottom out of the door frame
Carefully adjust the door window glass -2- until the screws -3- are accessible.
Unscrew screws -3- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Slide the cover -1- down slightly -arrow A- , detach it from the door and then guide it up and out -arrow B- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.