LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Macan S >> Repair and Diagnosis >> External Pages >> Different car >> Section 758 (30 - Clutch, Control) >> WM 304919 Removing and installing double clutch >> Subsequent work

Subsequent work

WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install new radial shaft seal. → 386955 REPLACING SEALING RING FOR DOUBLE CLUTCH
  2. Install flywheel. → 136019 REMOVING AND REINSTALLING FLYWHEEL
  3. Top up ATF. → 370255 CHANGING ATF

    Information 

    The PIWIS Tester  instructions take precedence and in the event of a discrepancy these are the instructions that must be followed. Deviations may occur with later software versions.

  4. Calibrate the double clutch using PIWIS Tester II 9818  .
    1. 4.1. PIWIS Tester II 9818  must be connected to the vehicle before starting the System Tester.
    2. 4.2. Switch on ignition.
    3. 4.3. Select the required vehicle type.
    4. 4.4. Select the double clutch transmission control unit and press >> to continue.
    5. 4.5. Select the Maintenance/repairs menu and press >> to confirm your selection.
    6. 4.6. Select "Calibration after replacing transmission mechanism components/double clutch" and press [F8] to start.
    7. 4.7. The message "Calibration completed successfully" appears. Press [F12] to end the process.
    8. 4.8. Change terminals.
    9. 4.9. Wait 30 seconds.
    10. 4.10. Switch on the ignition.
scientia non olet · About LEMON Manuals