Information on transfer gear with GNC plates: Notes

WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

Transfer gear with gas nitrocarburised (GNC) "hardened" steel plates.

If the transfer gear is replaced, the software must always be adapted .
For transfer gears with GNC plates, only the all-wheel software version 1360 (Part No.: 95B927755CB) I-no. LU2 must be used .

Transfer gear

Porsche part number of control unit after commissioning

Software version of control unit after commissioning

Part number on transfer gear

PR number⁽¹⁾

PET2 Parts Catalogue

without GNC

95B927755BJ

1204

95B341010

with GNC

95B927755CB

1360

95B341010 A

LU2

95B341010 A

⁽¹⁾

(Can be read out of the vehicle order: [F7] Additional menu -> Maintenance of vehicle data) The PR number is written automatically during commissioning (only for control unit replacement including transfer gear). For vehicles produced from week 12/2018, this is assigned to the vehicles at the factory. The relevant software is programmed using the Tester based on the PR number.