Technical values
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATION
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| M8 screws securing cardan shaft to rear axle differential | Step 1 | Tightening torque | 10 Nm (7.5 ft. lb.) | ||
| M8 screws securing cardan shaft to rear axle differential | Step 2 | Tightening torque | 24 Nm (18 ft. lb.) | +/-1.5 Nm (+/-1 ft. lb.) | |
| M8 screws securing cardan shaft to rear axle differential | Final tightening | Torque angle | +90° | +/-5° | |
| Screws on rear tunnel cross member | M10 x 30 | Tightening torque | 55 Nm (41 ft. lb.) | ||
| Fastening nut securing heat shield to body | Tightening torque | 2.1 Nm (1.5 ft. lb.) | |||
| Screws securing heat shield to tank holder | Tightening torque | 15 Nm (11 ft. lb.) | |||
| Screws on front tunnel support | M12 x 25 | Tightening torque | 55 Nm (41 ft. lb.) | ||
| Fastening screw securing cardan shaft bearing to body | M8 x 25 | Tightening torque | 20 Nm (15 ft. lb.) | +/-3 Nm (+/-2 ft. lb.) |