Technical values
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATION
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Lower control arm to front-axle carrier | M12 thread/always use new screws or bolts and nuts following removal | Final tightening | +180° | ||
| Lower control arm to wheel bearing housing | M14 thread/always use new nuts following removal | Tightening torque | 140 Nm (104 ft. lb.) | ||
| Fastening screw | Retaining bracket for engine mount | Tightening torque | 30 Nm (22 ft. lb.) | ||
| Fastening screws | Heat shield to front-axle carrier | Tightening torque | 9 Nm (6.5 ft. lb.) | ||
| Fastening screw | Heat shield to front-axle carrier | Tightening torque | 20 Nm (15 ft. lb.) | ||
| Fastening screw | Step 1, front-axle carrier to body | Initial tightening | 115 Nm (85 ft. lb.) | ||
| Fastening screw | Step 2, front-axle carrier to body | Final tightening | +90° | ||
| Fastening screw | Step 1, front-axle carrier to body | Initial tightening | 115 Nm (85 ft. lb.) | ||
| Fastening screw | Step 2, front-axle carrier to body | Final tightening | +90° | ||
| Fastening screws | Engine mount to front-axle carrier | Tightening torque | 55 Nm (41 ft. lb.) | ||
| Support to lock carrier | Tightening torque | 5 Nm (3.5 ft. lb.) | |||
| Support to chassis subframe | Tightening torque | 23 Nm (17 ft. lb.) | |||
| Fastening screw securing engine mount to front-axle carrier | Observe specified sequence! | Tightening torque | 30 Nm (22 ft. lb.) |