General information
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Air springs can become kinked/fall out
- Risk of damage to air springs
→ Deactivate the levelling system before raising the vehicle.
→ Check the bellows before lowering the vehicle.
Information
Always pay particular attention to the following before raising the vehicle:
- Deactivate the levelling system before raising the vehicle (press and hold the levelling system button for at least 10 seconds) .
- If a transmission range is engaged while the vehicle is raised, the levelling system must first be deactivated using PIWIS Tester II 9818 . To do this, select >>Levelling system/PASM<<>>Drive links/checks<<>>Activate/deactivate levelling system (without wheel rotation detection)<< in the control unit overview. Select the value "Deactivate levelling system (permanently)" and press "Start" [F8] to execute the function. Re-activate the levelling system when the work is complete. To do this, select >>Drive links/checks<<>>Conclude initial commissioning>> and then select "Activate levelling system" under >>Activate/deactivate levelling system (without wheel rotation detection)<< and execute the function by pressing "Start" [F8] .
- All functions (e.g. ventilation/filling) of the PASM control unit are deactivated as soon as the levelling system has been deactivated using the function >>Activate/deactivate levelling system (without wheel rotation detection)<< .