Teaching while driving
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
A procedure in PIWIS Tester II 9818 can be used to teach the wheel ID's while driving: >>Tyre Pressure Monitoring (TPM) system <<>>Maintenance/repairs<<>>Teach wheel ID's<<>>Teach wheel ID's while driving<<.
The wheel ID's can also be taught without using the System Tester.
The following points must always be observed:
- Allow an idle time of at least 5 minutes before teaching the wheel ID's (wheel electronics units are then in Sleep mode).
- Briefly accelerate the vehicle to over 25 km/h (15 mph) in order to teach the wheel ID's (wheel electronics units are then in Burst mode).
- Then continue driving at any speed (even < 25 km/h or 15 mph) for max. 10 minutes.
- Teaching was successful if a pressure reading is displayed in the instrument cluster for all wheel positions.