Brake disc measurement sheet
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Information
Notes on checking and measurement points can be found in:
- Technical data relating to the tests . → 4650TW TECHNICAL DATA/BRAKE WEAR LIMIT
- Description of Tests 1-3, front . → 465002 CHECKING FRONT BRAKE DISCS (WEAR ASSESSMENT)
- Description of Tests 1-3, rear . → 465302 CHECKING REAR BRAKE DISCS (WEAR ASSESSMENT)
A copy or print-out of the data card shown here can be used to document the measured result. The data cards cannot be ordered.
- Make a copy or print-out of the data card shown here.
Information
- Actual values that are identical in all versions are already entered!
- These values may change in the course of further development . Check them if necessary and add the new values as required. → 4650TW TECHNICAL DATA/BRAKE WEAR LIMIT
- Before taking measurements (Test 1 to Test 3), enter the general data, vehicle type and the missing nominal values (new brake disc thickness/brake disc wear limit) in the data card.
- Carry out measurements (actual status) and enter the values in the data card.
- If brake discs are to be replaced, carry out Test 2 with the new discs again and enter the latest values in a new data card.
| Brake disc measurement | ||||||
| Customer: | Rep. Order No.: | |||||
| Brake disc measurement | ||||||
| Street: | Porsche VIN: | |||||
| City: | Reg. number: | |||||
| Telephone: | Date of first registration: | |||||
| Vehicle type: | Odometer reading [km/miles]: | |||||
| Checker: | Date/Signature | |||||
| Nominal values | ||||||
| Test 1 = Brake disc thickness | ||||||
| - Brake disc thickness, new [mm]: | Front: | Rear: | ||||
| - Wear limit [mm]: | Front: | Rear: | ||||
| Test 2 = Lateral runout | ||||||
| - Brake disc installed [mm] | max.: | |||||
| - Wheel hub | max.: 0.02 | |||||
| - Brake disc removed [mm] | max.: 0.03 | |||||
| Test 3 = Thickness tolerance of brake disc | ||||||
| Thickness tolerance of brake disc [mm] | max.: | |||||
| Measured values (actual values) [mm] | front left | front right | rear left | rear right | ||
| Test 1 = Brake disc thickness (measured at 3 points, each offset by 120°) | ||||||
| Measurement point A | ||||||
| Measurement point B | ||||||
| Measurement point C | ||||||
| Test 2 = Lateral runout | ||||||
| - Brake disc installed | ||||||
| - Wheel hub | ||||||
| Brake disc measurement | ||||||
| - Brake disc removed (difference wheel hub/brake disc installed) | ||||||
| Test 3 = Thickness tolerance of brake disc (1) | ||||||
| Thickness tolerance (1) | ||||||
|
||||||