Test conditions
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Information
Always pay particular attention to the following before raising the vehicle:
- Deactivate the levelling system before raising the vehicle (press and hold the levelling system button for at least 10 seconds) .
- If a transmission range will be engaged while the vehicle is raised, the levelling system must be deactivated beforehand using the PIWIS Tester . To do this, select >>Levelling system/PASM<<>>Drive links/checks<<>>Activate/deactivate levelling system (without wheel rotation detection)<< in the control unit overview. Select the value "Deactivate levelling system (permanently)" and press "Start" [F8] to execute the function. Re-activate the levelling system when the work is complete. To do this, select >>Drive links/checks<<>>Conclude initial commissioning>> and then select "Activate levelling system" under >>Activate/deactivate levelling system (without wheel rotation detection)<< and execute the function by pressing "Start" [F8] .
- All functions (e.g. bleeding/filling) of the PASM control unit are deactivated as soon as the levelling system has been deactivated using the function >>Activate/deactivate levelling system (without wheel rotation detection)<< .
- Transmission must not be in limp-home mode.
- Warm up transmission in lower load range. Switch all transmission ranges several times while doing so.
- Read out the ATF temperature using the PIWIS Tester .
- ATF temperature: 30 - 50°C.
- Selector lever is in position P.
- Parking brake actuated.
- Test and filling process at idle speed.
- Air conditioning and heating switched off.
- The ATF temperature must not be higher than 30°C at the beginning of the test.
- If the ATF temperature is higher than 30°C, let the transmission cool down.