Installing battery-starter wire harness (from external power connection to starter)
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Installation is performed in reverse order to removal.
- Tighten fastening nut securing B+ positive cable to the potential distributor on the longitudinal member. Tightening torque 20 Nm (15 ft. lb.)
- Tighten fastening nut securing ground line to the longitudinal member. Tightening torque 20 Nm (15 ft. lb.)
- Tighten fastening nut securing positive cable at the jump-start point. Tightening torque 7.5 Nm (5.5 ft. lb.)
- Tighten connection terminal securing B+ positive cables to the jump-start point. Tightening torque 20 Nm (15 ft. lb.)
- Tighten fastening nut securing positive cable to B+ positive cable. Tightening torque 7.5 Nm (5.5 ft. lb.)