Installing front airbag sensor
WARNING: This page is about a different car, the 2016 Porsche Macan and 2015 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Incorrect handling of safety bolts
- Danger of injury
- Loss of torque
→ Always use new fastening screws and nuts following removal.
→ Observe specified tightening torques.
→ Carry out a visual inspection of all re-used parts.
Information
- Some of the repair illustrations show only one side of the vehicle or a similar component .
- Naturally, some steps also have to be performed on the opposite side of the vehicle as well .
Information
- Make sure that the airbag sensor is positioned correctly .
- Position the sensor -B-
.
Information
Always replace screws and nuts after customer service and reworking. Micro-self-locking screws must not be treated, greased or loosened and then screwed on again.
- Tighten fastening screw -1- for front airbag sensor to → Tightening torque: 9 Nm (6.5 ft lb.) .
- Plug in electric plug connection -A- and lock it -a- .